- #Filemaker fmdiff change creator version how to
- #Filemaker fmdiff change creator version pdf
- #Filemaker fmdiff change creator version driver
Platform related issues - valid mostly for FileMaker 6 and belowĪ FileMaker file prints fine on one platform, but not on the other. Here it really pays to have a subscript for printing - instead of print commands all over the place - since there is only one place to modify. Note: For scripted prints, after returning the file to the Macintosh platform, the script steps Page Format and Print have to be redefined, since the same information is stored within the script step. Here it comes handy if you have just a few separate scripts for printing which you call as SubScripts.
#Filemaker fmdiff change creator version driver
So in case moving between platforms does not help (possibly with scripted prints) you will have to redefine the print scripts on the new platform with the new driver selected as default.
The old settings won't fit for the new one. That same procedure may also cure problems after installing a new printerįor obviously the same reason there could be problems when changing the printer. There is no reason to keep those settings in the file! Quod erat demonstrandum (which was to be demonstrated). Then move the files back to the Mac and the next print will restore the settings for the currently selected default printer with the correct file name. This will remove the Macintosh settings and replace them with the Windows ones. There is an easy way to do just that: Move the file to the Windows platform and perform a Print (to any driver - don't waste any paper). The best thing would be to remove these definitions all together. Not even a He圎ditor is recommended, since it is dangerous and you would have to use a name of the same or a lesser length, filled with blanks or zeros up to the original size. You should not fiddle on the file with an editor, this destroys the file.
#Filemaker fmdiff change creator version how to
How to get rid of that original file name? So redefining the Print Setup and Print script steps in FileMaker Pro 10 will remove the old printer information, including the original file name. This and related problems are only partially improved with FileMaker Pro 10 as the printer definition is no longer stored within the file but still within the Print and Print Setup script steps. If needed for a job it just could be generated at any time (will be proved later). So whenever FileMaker performs a Print command it uses these settings stored within the file and shows the original file name! Within that printer definition on a Macintosh the original file name is stored, like. Whenever a new file is created the printer definition for the currently selected printer (some 5 to 13kb, depending on printer and platform) is saved within that file - and lives there forever.
#Filemaker fmdiff change creator version pdf
The files were properly renamed for the next customer, but when previewing or saving as PDF or looking at the printer queue while printing, the name of their competition showed up - not a good recommendation, is it? It had happened that a FileMaker solution was sold to different customers and some files were bearing the customer name. This new phenomena applies to the Macintosh platform since FileMaker® Pro 7. Print on Windows Old Filename in Print Dialog and other problems
Problems with printing from a FileMaker file
0 kommentar(er)
